Precision Marine Installations by Radioworld

10/20/2026

The Lund Rebel 1750 XS with Jet Drive Mercury that has seen some stuff 👀

This boat came through for a technical diagnostic and major cleanup, and left with a few nice to have’s that the customer wanted to add on 👌

✔️ Humminbird Target Lock and Mega Live 2 re-installation and troubleshooting
✔️ Trolling motor cable management and wiring tidy at the bow to manage 2x Units and 2x FFS Systems
✔️ GeigerTec Dual Extreme bow mount
✔️ Garmin Echomap Ultra 2 126SV upgrade from the 106SV
✔️ Battery bay reconfiguration and cleanup with upgraded hardware and wiring for the electronics
✔️ Apex Lithium trolling motor battery (dual 36V 60AH) and bow electronics battery (12V 100AH) configuration with dual voltage (12/36V) charger
✔️ GeigerTec Extreme Mount at the tiller console to replace the RAM Mount
✔️ General wiring tidy and software updates + network configurations

10/06/2026

Triton 21 TRX in for some key reconfigurations in the back of the boat and some fun up front ⬇️

✔️ Battery compartment cleanup and reorganization — this includes new connections, wire routing and management
✔️ Addition of Apex Lithium 160ah battery isolate for running the electronics with a dedicated power harness from SeaClear and a battery backup system allowing the customer to select from either the starting battery or electronics battery to power the fishing electronics on this boat
✔️ New in-hull transducer for the Lowrance HDS16 at the dash
✔️ Garmin Livescope 2 42HD added on the bow for a dual Livescope system
✔️ Console and bow wiring cleanup with clean trolling motor management to cap it off 👌

09/21/2026

This BassCat Puma FTD limped into the shop and left feeling like a whole new boat ⬇️

We kicked this one off with a complete battery compartment scrub before we got started 🧼

✔️ Battery compartment overhaul with a full replacement of cables and connections to get rid of any existing corrosion and failure points — we relocated the power switch from the bottom of the bilge and got everything straightened out properly
✔️ GeigerTec BassCat Classic Dash Mount to hold a new Garmin Echomap Ultra 2 166SV
✔️ LVS34 Upgrade from the LVS32 in the bow — featuring a Scope Switch and the Flexroute Wire Management System
✔️ Dual Extreme Bow Mount replacing the RAM Mount and floor mounted gimbal that resided on the bow previously — we made sure to throughbolt the dual stack mount for rough water stability
✔️ Garmin Echomap Ultra 2 126SV on the bow alongside the pre-existing 12” Echomap
✔️ Full Garmin Network configuration and setup
✔️ GeigerTec JackPlate Transducer Mount for the GT56 on the Jackplate
✔️ PowerPole Blade Anchor Warranty Service replacing a broken knuckle and outfitting the poles with brand new spikes

09/17/2026

09/16/2026

This fully customized iKon Boats left the factory with every option on it, and it came to Precision Marine Installations by Radioworld for even more 👀 ⬇️

✔️ Garmin Force Pro 57” with GT56 and flood light attachment
✔️ Troll Tamer on the Force Pro for rough water security
✔️ Dual Garmin Livescope 2 Setup with the LVS42HD and LVS44, both on GeigerTec Scope Switch Mounts — routed cleanly with the GeigerTec Wire Management Kit
✔️ Custom Painted GeigerTec Ikon Bow Plate with Fl**ge holding a Dual Extreme Bow Mount
✔️ Dual Garmin 9217XSV nestled in the GeigerTec 9### Series Gimbal Mounts
✔️ Dual Garmin 9213XSV on the dash on the GeigerTec Ikon Dash Mount
✔️ Full Garmin BlueNet Network setup and configuration
✔️ NMEA2000 network build in conjunction with the Power-Pole N2K Gateway for Charge and Anchor control integration with Garmin
✔️ GeigerTec Garmin GPS24XD Ikon Base holding the antenna for GPS Positioning and Heading
✔️ Garmin MOB Wireless kill switch installation and configuration
✔️ Power-Pole Charge keeping all 5 Apex Lithium Batteries batteries happy with AC and DC Power Management
✔️ Dual 160AH Apex Lithium in parallel for starting and electronics and Triple 36V60AH Apex Lithiums for endless trolling motor power
✔️ Garmin GT8 In-Hull and Garmin GT56 on the transom on a GeigerTec Jackplate Transducer Mount
✔️ Dual 10ft Power-Pole One Pump Blade
✔️ Dual GeigerTec Base Plates for the Mega FFS Pole on the rear deck
✔️ RMP Blade Anchor Light

09/11/2026

The newest BASSMASTER Elite Series Champion Evan Küng and his passenger came by the shop today, before the last string of tournaments for the season 🏆

09/10/2026

Simple, yet effective Great Lakes trolling setup on this 2026 Lund 2075 Fisherman that will double as a great family boat ⬇️

✔️ Garmin Kraken 75” on the bow with GT56 transducer
✔️ Garmin 126SV Ultra 2 on a GeigerTec Extreme Mount at the dash and GT56 on the transom
✔️ CFS Track on the aft to accommodate a Garmin 166SV on Traxstech Low Profile Mount and BBT Gimbal
✔️ GeigerTec Mega Mount Gen 2 FFS Pole with Garmin LVS34 and quick disconnect bulkhead
✔️ Secondary Bulkhead on bow with pre-rig for the Garmin 166SV with a GeigerTec Extreme Mount on the bow
✔️ GMS10 Garmin Network Hub to keep everything talking and Livescope displayed across the entire boat
✔️ 36V 165AH Lithium trolling motor setup with NOCO 10X3 Charger

08/24/2026

Ranger Z185 in for a complete re-rig from bow to stern ⬇️

✔️ Garmin LVS34 with the GeigerTec Scope Switch on the Minn Kota Ultrex Quest
✔️ Flexroute Cable Management keeping the LVS34 cable away from pinch points and fixed on the shaft
✔️ New Dual Live Mount from GeigerTec with the Over the Pedal Offset Bar — Extension Pole option for hard core scoping
✔️ BBT Ranger Z185 Dual Dash with two new Ultra 2 Echomap 106SV from Garmin with the GT56 off the transom
✔️ Garmin GPS24XD GPS Puck and NMEA Network
✔️ GLS10 relocation into the starboard locker for easier access and serviceability
✔️ Battery compartment overhaul featuring an Apex Lithium 160ah battery to run the motor, pumps, and electronics
✔️ Dual Bank Charger for 12V / 36V Battery Configuration from Apex Marine
✔️ SeaClear Power Wiring Harness to isolate the electronics from factory wiring, delivering clean power and no voltage drop
✔️ Dual 36V trolling motor battery configuration